Dishwasher Repair in Toronto & the GTA

Dishwasher repair in Toronto and the GTA covers standing water in the tub, dishes coming out gritty, seepage under the toe kick, a stale drain smell, and cycles that never begin.

  • Dishwasher repair
  • Dishwasher repair, weekends included
  • Built-in and panel-ready dishwashers
60-Day Parts & Labour Warranty4,530+ repairs completed since 2013
Call for Dishwasher Repair
  • Same-day service available
  • Licensed & Insured
  • 13+ Years Experience

New request

Slots today

Book dishwasher repair

Dishwasher

Service call $120 + HST covers the full diagnosis. Written quote before any work — or call+1 (416) 885-0963.

  • Same-day slots across Toronto and the GTA — typical arrival ~60 minutes
  • Service call $120 plus HST covers the full diagnosis, not just a look
  • 60-Day Parts & Labour Warranty — the terms are printed on your invoice
  • OEM parts by default on built-in and luxury appliances
  • Insured — $2M Liability, underwritten by Wawanesa
  • 4,530+ repairs completed since 2013
  • Mon–Sun 8:00 AM – 9:00 PM — we call back within 15 minutes
  • Written quote before any work starts — seniors save $50

Jump to your symptom:

We repair built-in and panel-ready dishwashers across Toronto and the GTA, usually the same day. Most calls come down to drainage, spray coverage or a leak sensor that has tripped — and a good share of them clear with a filter clean we will talk you through on the phone. Service call $120 plus HST, written quote first, 60-day parts and labour warranty.

  • Missing drain high-loops on builder installs are a recurring find in newer Mississauga and Markham condos — the machine drains badly from the day it was fitted, and correcting the routing fixes it permanently.
  • Roughly half the Bosch E24 calls we take are solved by the owner over the phone with a filter clean, which is a visit we would rather not charge for.
— Not draining

Why is there standing water in my dishwasher?

Water left in the bottom means the drain path is blocked or the pump has stopped moving it. On Bosch machines this shows as E24 or E25, and the filter assembly at the bottom of the tub is the first thing to check — it is designed to be removed by hand.

Likely causes

  • Filter assembly clogged with food debris and grease
  • Drain pump impeller jammed, commonly by a shard of glass or a fruit pit
  • Drain hose kinked or missing its high-loop, so water siphons back
  • Air gap at the sink blocked, where one is fitted
  • Garbage disposal knockout plug never removed after installation

What we do

We clear the filter and sump, inspect the pump impeller for damage, and confirm the drain hose has a proper high-loop. That last one is the fault we find most often in new builds: the builder skipped it, and the machine has been draining badly since day one.

What affects the cost

Filter and hose work is the low end. A replacement drain pump is a modest part, and a damaged impeller is not worth cleaning — it will fail again.

— Not cleaning

Why are my dishes coming out dirty or filmy?

Poor cleaning is usually water not reaching the dishes: blocked spray arm jets, a clogged filter, or limescale from GTA tap water. A white film on glassware specifically points at hard water rather than at a broken machine.

Likely causes

  • Spray arm jets blocked with debris or scale
  • Filter clogged, so the machine recirculates dirty water
  • Wash pump weak or its impeller worn
  • Water not reaching temperature — heater or thermostat fault
  • Limescale buildup from hard water, plus detergent doing less than you think

What we do

We check spray arm rotation and jet coverage first, measure the wash temperature, then look at the pump. If the answer is scale rather than a fault, we say so and show you the descaling routine instead of selling you a part.

What affects the cost

Cleaning and spray arms are inexpensive. Wash pumps and heaters cost more, and on a quiet premium machine the pump is a significant part.

— Leaking

Why is my dishwasher leaking?

A dishwasher leak is urgent in a condo and merely expensive in a house — either way it should not wait. Water in the base pan trips the Aquastop float on Bosch and Siemens machines, which is what E15 means, and the machine will refuse to run until it is cleared.

Likely causes

  • Door seal perished or displaced
  • Water inlet valve leaking slowly behind the machine
  • Pump or sump seal failed
  • Overfilling because the pressure sensor is out of range
  • Detergent overdosing producing foam that escapes the door

What we do

We dry the base pan, run the machine and find the source at the stage it appears rather than guessing from the puddle. Then we reset the safety float — and in a condo we check the cabinet underneath for damage the owner has not noticed yet.

What affects the cost

Seals and hoses are inexpensive. A tub or sump leak on an older machine is where replacement often wins, and we will tell you that.

— Won't start

Why will my dishwasher not start?

A dishwasher that shows lights but never fills is usually held back by the door latch or a safety condition. If the machine is completely dead, the fault is upstream: the outlet under the sink, or the switch that feeds it.

Likely causes

  • Door latch not confirming closure
  • Aquastop or leak sensor tripped, blocking the cycle
  • Control lock or delay start engaged — not a fault at all
  • Power lost at the outlet under the sink, often on the disposal switch
  • Control board failure

What we do

We confirm power at the appliance, then read the fault memory rather than assuming. A surprising number of these calls end with us finding a tripped switch under the sink, and we would rather tell you that than invent a repair.

What affects the cost

Latches and switches are inexpensive. Control boards are the expensive outcome, particularly on built-in premium units.

— Bad smell

Why does my dishwasher smell?

A dishwasher that smells is holding water somewhere it should not. Standing water in the sump, a filter left uncleaned, or a drain hose without a high-loop letting sink water back in — those three cover almost every case.

Likely causes

  • Filter and sump holding old food debris
  • Drain hose without a high-loop, siphoning waste water back
  • Food trapped under the spray arm or in the door seal channel
  • Machine only ever run on eco cycles, never hot enough to clear grease

What we do

We strip and clean the filter and sump, correct the drain hose routing, and run a hot cycle to verify. Then we show you the ten-minute monthly routine that stops it coming back — it costs you nothing and works.

What affects the cost

Usually labour only. Correcting a builder’s drain hose routing is a small job that permanently solves a problem people live with for years.

— Our work

Dishwasher Repair we have had open recently

Our own photographs from service calls across the GTA — panels off, parts out.

  • GE dishwasher repair in Toronto — built-in dishwasher under the counter with the lower kick plate removed and tools on the countertop

    GE dishwasher with the toe kick removed

  • Dishwasher repair in Toronto — control module lifted out of the opened dishwasher door, with the drying fan and wiring below

    Dishwasher control module out of the door

  • KitchenAid dishwasher repair in Toronto — built-in dishwasher with the door open, both racks loaded, cycle labels and the detergent dispenser on the door

    KitchenAid dishwasher with both racks out

More of the same on our photo gallery.

— Pricing

Simple, honest pricing

  • Service call & diagnostic$120 + HSTCovers the visit and full diagnosis
  • Written quote on-siteBefore any workNothing proceeds until you approve it
  • Senior discount$50 offMention it when booking

What affects the repair price

  • The part itself — a door switch and a sealed-system component are different worlds.
  • Age and brand — luxury built-ins need factory-spec parts, and those cost more.
  • Access — a stacked unit in a condo closet takes longer to reach than a free-standing machine.

We do not publish repair price ranges. Senior Discount — $50 applies on top of the quoted job, and there are no trip surcharges or weekend premiums.

— Any brand

Brands we fix most often

We carry OEM parts for the brands below and several hundred more. On built-ins we fit factory parts only.

— How the visit works

From your call to a working appliance

  1. Booking confirmation on a phone in a kitchenStep — 01

    You call or book online

    We confirm the appliance, the symptom and your postal code, and call back within 15 minutes in business hours.

  2. Technician at a front door with a tool caseStep — 02

    Technician arrives with parts on board

    The van carries the components that fail most often on the brands we see daily.

  3. Meter probes on an appliance terminal block beside a quote padStep — 03

    Diagnosis, then a written quote

    You see the number before any work begins, and nothing proceeds until you approve it.

  4. Replacement pump being fitted, the worn part set asideStep — 04

    Repair and test cycle

    We run the appliance before leaving and log the job number that activates your 60-day parts & labour warranty.

Job #4477 · Dishwasher · Mississauga

Fixed
Brand
Bosch
Model
SHXM63WS5N
Time on site
60 min
Total
$189 + HST
— Real repair

Bosch E24 Drain Error at Square One

A Bosch dishwasher in a Square One condo kept showing E24 after the owner had already cleaned the filter twice. The blockage was one stage further along.

Read the full work order
— FAQ

Dishwasher Repair questions

What do E24 and E25 mean on my Bosch dishwasher?

E24 means the drain is restricted — usually the filter, and usually something you can clear yourself in ten minutes. E25 means the drain pump itself is blocked, often by glass or a bone fragment, and that one needs the pump opened up. We will tell you which is which on the phone before booking a visit.

Does Toronto water cause dishwasher problems?

Hard water in the GTA leaves scale on the heater and spray jets over time, which shows up as a white film on glassware and gradually worse cleaning. It is not a fault, and it is not something a new machine fixes. Rinse aid plus a periodic descale keeps it in check.

Is it worth repairing a dishwasher or should I replace it?

Pumps, valves, latches, seals and spray arms are all sensible repairs at any age. A control board on a mid-range machine over eight years old is usually where replacement wins, and a tub leak almost always is. We give you that verdict before you commit to anything past the diagnostic.

Do you repair panel-ready and integrated dishwashers?

Yes. Integrated units need the custom panel removed carefully and refitted properly, which takes longer than a standard machine. We book the extra time rather than rushing work in cabinetry that costs more than the appliance.

Why are my dishes still wet at the end of the cycle?

Most European machines use condensation drying rather than a heating element, so plastics in particular come out damp — that is design, not failure. Rinse aid makes a real difference. If everything including glass is soaking wet, the heater or the thermostat is worth checking.

— Near you

Dishwasher repair in your area

Each area page covers what is different about the housing, the appliances and the access there.

Dishwasher down? We can be there today.

Call +1 (416) 885-0963or book online
— Related
Call NowBook Online
+1 (416) 885-0963