KitchenAid Appliance Repair in Toronto & the GTA

We repair KitchenAid refrigerators, dishwashers, wall ovens, cooktops and range hoods across Toronto and the GTA. These share a parts platform with Whirlpool, which means availability is good and most repairs finish on the first visit. Service call $120 plus HST, 60-day parts and labour warranty.

KitchenAid appliances we service

Refrigerators
Dishwashers
Wall ovens
Cooktops
Range hoods

— What we see most

Common KitchenAid problems

We repair KitchenAid built-in appliances only. Stand mixers and other countertop products are not something we service — we will tell you that on the phone instead of charging a visit.

01
Ice maker producing nothing or hollow cubes
02
Convection oven baking unevenly
03
Dishwasher leaving film on glassware
04
Refrigerator control board faults after a power surge

— Error codes

KitchenAid error codes and what to do

Half of these you can clear yourself in ten minutes. We would rather tell you that than book a visit you do not need.

Common KitchenAid error codes and what to do about them
Code	Appliance	What it means	What to do
F1 E1	Oven	Control board failure	Call us: board replacement
F2 E0	Oven	Stuck touchpad key	DIY: clean the panel, cut power for 5 min → then call us
F3 E0	Oven	Oven temperature sensor open circuit	Call us: sensor replacement
F5 E0	Oven	Door latch fault — lock not confirming	Call us
F7 E1	Washer	Drive motor or speed sensor fault	Call us
F8 E1	Dishwasher	Low water flow into the machine	DIY: check the supply valves and inlet screens
F9 E1	Dishwasher	Drain taking too long	DIY: clean the filter → if persists, call us
F6 E2	Refrigerator	Control communication error	Call us

F1 E1Oven
Control board failure
Call us: board replacement
F2 E0Oven
Stuck touchpad key
DIY: clean the panel, cut power for 5 min → then call us
F3 E0Oven
Oven temperature sensor open circuit
Call us: sensor replacement
F5 E0Oven
Door latch fault — lock not confirming
Call us
F7 E1Washer
Drive motor or speed sensor fault
Call us
F8 E1Dishwasher
Low water flow into the machine
DIY: check the supply valves and inlet screens
F9 E1Dishwasher
Drain taking too long
DIY: clean the filter → if persists, call us
F6 E2Refrigerator
Control communication error
Call us

— Parts

Why OEM parts matter on KitchenAid

KitchenAid built-ins share components with the wider Whirlpool platform, so parts are usually available and reasonably priced. Where it matters is the control boards: the firmware differs between series even when the board looks identical, and fitting the wrong revision produces faults that make no sense against the symptom.

Factory parts on anything touching the control or sealed system
We tell you when an aftermarket part is genuinely fine and cheaper
Part numbers go on your invoice, so the next technician is not guessing

— Our work

KitchenAid appliances we have worked on

KitchenAid dishwasher with both racks out

More of the same on our photo gallery.

— Pricing

Simple, honest pricing

Service call & diagnostic$120 + HSTCovers the visit and full diagnosis
Written quote on-siteBefore any workNothing proceeds until you approve it
Senior discount$50 offMention it when booking

What affects the repair price

The part itself — a door switch and a sealed-system component are different worlds.
Age and brand — luxury built-ins need factory-spec parts, and those cost more.
Access — a stacked unit in a condo closet takes longer to reach than a free-standing machine.

We do not publish repair price ranges. Senior Discount — $50 applies on top of the quoted job, and there are no trip surcharges or weekend premiums.

— FAQ

KitchenAid repair questions

Do you repair KitchenAid stand mixers?

No, and we will say so on the phone rather than charging a visit to reach the same answer. We repair built-in KitchenAid appliances — refrigerators, dishwashers, wall ovens, cooktops and hoods.

My KitchenAid ice maker makes hollow or tiny cubes. Why?

That is a water-flow symptom, not an ice maker failure. An overdue filter or a partially restricted inlet valve gives a short fill, and a short fill gives small or hollow cubes. Cube size is genuinely the earliest warning sign of a restricted water path.

Why does my KitchenAid oven bake unevenly?

Usually calibration drift or a convection fan that has slowed. We log a full cycle with an independent probe rather than taking a single reading, then recalibrate or replace the sensor or fan based on what the log actually shows.

Are KitchenAid and Whirlpool parts interchangeable?

Often mechanically, yes — but not always electronically. Boards and sensors can differ in revision between series, and fitting a near-match is how you end up chasing a fault that was never there. We match parts by model, not by family.

— Near you

KitchenAid repair across the GTA

KitchenAid appliance acting up? We know these machines.

Call +1 (416) 885-0963 or book online

— Related